PDA

View Full Version : a few questions


baldiejr
02-15-2006, 08:34 AM
my springs are wore out. where can i find cheap replacements?
how much lift is necessary to run 29 inch tires (5.5 inch tread width)? can i just clean up the wheel wells rather than lift?
does a lockright up front make steering difficult with stock components?
how much can these tucks tow?

thank you!

Billjohn
02-15-2006, 09:11 AM
1. Junkyard, ebay
2. Bend the seams in the wheelwell over with a BFH and you might get away with it.
3. When on the road, you just unlock the front hubs and you will never know the locker is there. On the trail it doesn't matter.
4. Manual says you can tow a trailer rated at 1000 lbs.

{I love an early morning quiz}:turn-l:

purevil71
02-15-2006, 12:06 PM
my springs are wore out. where can i find cheap replacements?
how much lift is necessary to run 29 inch tires (5.5 inch tread width)? can i just clean up the wheel wells rather than lift?
does a lockright up front make steering difficult with stock components?
how much can these tucks tow?

thank you!

Most of the SPOA's we have done, guys were fitting 31's with out any problems. And like Bill said, you gotta watch those body seams.

baldiejr
02-15-2006, 06:04 PM
Darn. I was hoping someone knew of a place to get new stock springs.

zukking01
02-15-2006, 06:55 PM
New stock springs normally go for $129 and 2 lift go for $99. Used springs on ebay usually go for $20 a piece when listed. Put a wanted ad in zukikrawlers and I bet someone hase some left over from a wrangler swap. Ask a krawler.