View Full Version : header and bolton system
08-09-2006, 01:51 AM
im planning on replacing my exhaust system since it is stock and i was wondering if the headers from petroworks will work the the manifold back bolton system from roadless gear
08-09-2006, 10:01 AM
It won't bolt straight up, but it can be done!
I just finished installing a Thorley Header and a Cat-Back 2" system from Trail Tough and it's basically the same thing. The exhaust took about 15 minutes to install after I put the zook on ramps and cut out the old stuff. I just left the 'down tube' off to the side. Then I installed the header and saw where it needed to be joined up front. I (carefully) drove it down to the local muffler shop and they made a connecting tube that bolts on. They used the flanges from the new down tube and the header. It is a weird angle, because I didn't want to damage the new system and I wanted to use the stock hangers. I will get a picture or two for you in a little while...
vBulletin® v3.8.7, Copyright ©2000-2016, vBulletin Solutions, Inc.