Axle removal?

[xxlf250]

Well I searched and no luck I want to install my newfields and I have never had to tear apart my front end, it seems easy, one question is take apart the hubs, do you need to take the 6 cap bolts off and then the 6 that hold it to the rotor? Anyway any info would help thanks.

Is this a newbie question. 2finger

[xxlf250]

I think I got it , with the birfied rings I had installed I think I have to tear down the complete hub, spindle, felts etc....Just to get the axle out.
no easy way out of this.

[Zee]

with the rings the housing had to be opened up.You are correct in that you have to remove the knuckle out.
Z

[Itsmejoe231]

Is this a newbie question. 2finger

That is OK. We wont tell anyone. :funny:






I had to ask the first time I did it too. toast

[xxlf250]

Well its done, now wait for the locker install and rewind the process.:dance:

[TX_ZUKI]

Well its done, now wait for the locker install and rewind the process.:dance:
:dance: Sweet deal!

[purevil71]

Don't forget the C-clips on the ends of the axles. I noticed that my Newfields had a lot of movement with out them. My stock axles didn't seem to move as much as the Newfields for some reasion.

[azhuntnut]

Well its done, now wait for the locker install and rewind the process.:dance:
Since you are an expert now, can you drive over and do mine for me?:welcome: My locker should be ready for the front this week and I have never pulled apart the front before. David

[xxlf250]

All I did was keep taking things off until it came out , and then I started working on my zuk:funny:

No really its not that bad, now I see the reason I got this rig I can work on it and most of this stuff is striaght forward. I really did keep unbolting things until the axles were able to slip out.